MakerBox 2 Super Electronics Component Kit with UNO R3
MakerBox 2:
Super UNO R3 Compatible Electronics Starter Kit – LCD, RFID, Motors & Sensors
A comprehensive UNO R3 compatible electronics starter kit, containing a wide variety of electronic components, modules and accessories for learning programming, experimenting with electronics and building your own projects.
Ideal for beginners, students, makers and electronics enthusiasts.
Supplied in a reusable plastic storage box, with the components organised for convenient storage.
Kit Contents
1 x Plastic storage box
1 x UNO R3 with USB Cable
1 x RC522 RFID kit
1 x 5V Relay
1 x IR Receiver Module
1 x 830 Point Breadboard
1 x SG90 Servo
1 x Prototype Expansion
1 x Power Supply Module
1 x Ultrasonic Sensor
5 x White LED
5 x Yellow LED
5 x Blue LED
5 x Green LED
5 x Red LED
1 x RGB LED
2 x Photoresistor
1 x Thermistor
2 x Diode Rectifier (1N4007)
2 x NPN Transistor (PN2222)
1 x Tilt Switch
5 x Button (small)
1 x 1 digit 7-segment Display
1 x 4 digit 7-segment Display
1 x Sound Sensor Module
1 x LCD1602 Module ( with pin header)
1 x IC L293D (motor driver)
1 x IC 74HC595 (shift register)
1 x Active Buzzer
1 x Passive Buzzer
1 x DHT11 Temperature and Humidity Module
1 x Potentiometer
1 x Joystick Module
1 x Membrane Switch Module
1 x Remote IR Controller
1 x 65 Jumper Wire
1 x Water Lever Sensor
1 x USB Cable
1 x 9V Battery Connector with DC
10 x Resistor (10R)
10 x Resistor (100R)
10 x Resistor (220R)
10 x Resistor (330R)
10 x Resistor (1K)
10 x Resistor (2K)
10 x Resistor (5K1)
10 x Resistor (10K)
10 x Resistor (100K)
10 x Resistor (1M)
10 x Female-to-male Dupont Wire
1 x Resistance Identification Card
Please Note
-
The UNO R3 is an Arduino-compatible board, not an Arduino branded product.
-
A computer is required for programming the controller.
-
Some experiments may require additional components, software or soldering.
-
Batteries are not included.
-
Suitable for electronics enthusiasts and supervised educational use.
A comprehensive starter kit offering a wide range of possibilities for electronics experimentation, programming, robotics, sensors and DIY projects.